Performance Analysis Of A Solar Dryer With Silica Gel Integration For Outlet Air Dehumidification

Suhaimi Misha; Eslam Ahmed Hashem; Mohd Afzanizam Mohd Rosli; Fatimah Al Zahrah Mohd Saat; Nor Faizah Haminudin; Fudhail Abdul Munir

doi:10.29284/hqxp9v44

Authors

Suhaimi Misha Faculty of Mechanical Technology and Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, Durian Tunggal, Melaka, 76100, Malaysia
Eslam Ahmed Hashem Faculty of Mechanical Technology and Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, Durian Tunggal, Melaka, 76100, Malaysia
Mohd Afzanizam Mohd Rosli Faculty of Mechanical Technology and Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, Durian Tunggal, Melaka, 76100, Malaysia
Fatimah Al Zahrah Mohd Saat Faculty of Mechanical Technology and Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, Durian Tunggal, Melaka, 76100, Malaysia
Nor Faizah Haminudin Faculty of Mechanical Technology and Engineering, Universiti Teknikal Malaysia Melaka, Hang Tuah Jaya, Durian Tunggal, Melaka, 76100, Malaysia
Fudhail Abdul Munir Mechanical Engineering Department, Faculty of Engineering, Universiti Teknologi Petronas, 32610 Seri Iskandar, Perak, Malaysia

DOI:

https://doi.org/10.29284/hqxp9v44

Keywords:

Solar drying, silica gel, desiccant, hybrid dryer, food drying, renewable energy

Abstract

This paper presents an experimental study on the integration of silica gel as a desiccant bed in a two-chamber solar dryer to improve outlet air conditions for reuse in drying applications. The system comprises a flat-plate solar air collector (forced convection via four fans-powered by solar PV), Drying Chamber 1 (DC1), a packed bed of silica gel for dehumidification, and Drying Chamber 2 (DC2). Mee wantan was used as the test product under low solar radiation conditions (average 452 W/m²). Seven measurement points were instrumented with temperature and humidity sensors, and solar irradiance was recorded using a pyranometer. Results show that the average outlet air temperature from DC1 increased from 37.88 °C to 39.29 °C after passing through the silica gel bed, while the average relative humidity decreased from 59.75% to 55.07%, indicating enhanced drying potential in DC2. The final product moisture content reached 21% in DC1 and 23% in DC2, with the small difference attributable to the improved air properties dehumidification and the short experimental window due to rain. The silica gel bed exhibited an approximate mass increase of 11 g, confirming the adsorption of moisture from the air by the silica gel. The regeneration by solar heating is proposed for continuous operation. The study demonstrates a practical, hygienic approach to reduce ambient dependency in solar drying and supports hybrid desiccant solar dryer designs for food processing.

References

[1] A. Sharma, C. R. Chen, and N. V. Lan, "Solar-energy drying systems: A review," Renewable and Sustainable Energy Reviews, vol. 13, pp. 1185–1210, 2009.

[2] O. V. Ekechukwu and B. Norton, "Review of solar-energy drying systems II: An overview of solar drying technology," Energy Conversion and Management, vol. 40, pp. 615–655, 1999.

[3] A. S. Mujumdar (Ed.), Handbook of Industrial Drying, 3rd ed., Boca Raton, FL: CRC Press, 2006.

[4] B. Norton, "Solar Drying," in Harnessing Solar Heat, Lecture Notes in Energy, vol. 18, Springer, 2013.

[5] A. A. El-Sebaii and S. M. Shalaby, "Solar drying of agricultural products: A review," Renewable and Sustainable Energy Reviews, vol. 16, pp. 37–43, 2012.

[6] Jebaraj S. and M. Y. Khan, "A review on solar dryers to evaluate the performance and drying characteristics for agricultural products," Renewable Energy and Sustainable Development, vol. 11, no. 1, pp. 1–16, 2025.

[7] M. Kumar and A. Yadav, "Comparative study of solar-powered water production from atmospheric air using different desiccant materials," International Journal of Sustainable Engineering, 2016.

[8] A. Kumar and A. Yadav, "Experimental investigation of solar driven desiccant air conditioning system based on silica gel coated heat exchanger," International Journal of Refrigeration, 2016.

[9] Y. Zhao, Y. Dai, and J. Zhang, "Experimental study on solar driven dehumidification system with silica gel coated heat exchanger in winter," Proc. ISES Solar World Congress, 2017.

[10] A. Zouaoui, L. Zili-Ghedira, and S. Ben Nasrallah, "Experimental Investigation of Air Dehumidification and Regeneration Operations Using Packed Bed of Silica Gel Particles," International Journal of Heat and Technology, vol. 34, no. 1, pp. 103–109, 2016.